BetterPhoto Q&A
Category: New Answers

Photography Question 

Holly K. Henkels
 

How to shoot w/ skin blemishes


Recently I photographed a wedding where the bride broke out in hives (really Bad) It is insane how much work I am doing in photoshop to get them out. I know B&W would be good in these situations. But I want to know if this happens again, is there anything I could have done while I was photographing her, that would help cut down on the photoshoping? ie...special filters, or lenses?


To love this question, log in above
September 24, 2008

 

W.
 
Flat lighting, a good MUA, and lots of pancake.

Have fun!


To love this comment, log in above
September 24, 2008

 

BetterPhoto Member
  I have very good luck with soft focus and diffusion filters when it comes to skin problems. Tiffen has a line of soft focus filters which I have used that work wonders. Other than that, softer lighting will help by lessening shadows.


To love this comment, log in above
September 24, 2008

 

Mark Feldstein
  Hi gang !!!

Personally, I prefer Krustez pancake mix since you just add water and the stuff dries like plaster of Paris. Makes a mother-in-law look a lot like either George Washington or a face off Mt. Rushmore.

Failing that, however, when I shoot portraits I carry a make-up kit, small but with basic stuff to enhance street make-up or perform minor miracles in situations like you mentioned here, Holly.

One product I like is some stuff called Derma Blend to use as a base and then add some poweder to knock down any shiny areas like forehead, chin and noses. I also carry some brushes, other concealers for shadows under eyes, eyebrow pencils, and clothes pins in the same small pack.
I don't like softar filters. I suppose they're good for an individual in one shot, but I just don't like the effect for couples, etc. I figure, with the cost of my lenses, why hang a piece of glass to unsharpen them. I think soft lighting is always a good idea though.

Take the time to shoot it right or prep the subjects right and no fixing, right?? You'd probably do well to try some experimentation with different techniques, including the softars, to see whether you can combine them or use them separately to produce the best results under different condtiions.
Take it light ;>)
Mark.


To love this comment, log in above
September 24, 2008

 
This old forum is now archived. Use improved Forum here

Report this Thread