 |
|
|
|||
|
|
BetterPhoto Q&A
To participate in the Forum, become a BetterPhoto member or Sign In.
|
|||||||||||||||||||||||||||
 Christopher A. Walrath  member since: 4/25/2006 |
Metering probs L358C Can anyone tell me why, when I put my perfectly working, albeit older than dirt, Vivitar 2800 via X sync chord into my Sekonic L358C meter why when I test the flash the meter won't read? Mark? Alan? Anybody? 5/9/2007 4:42:58 PM |
|
|
|
||
John H. Siskin
John-Siskin.com John's Photo Courses: 4-Week Short Course: An Introduction to Photographic Lighting 4-Week Short Course: Getting Started in Commercial Photography 4-Week Short Course: Portrait Photography Lighting on Location and in the Studio |
Hi Christopher, Since I almost always use my Sekonic when I meter for a film camera outdoors it is usually not set to strobe. So I usually forget to change it back to strobe when I do use it in the studio. I don’t suppose that is the problem, but at least it would fit the conditions. Thanks, John Siskin 5/9/2007 8:01:54 PM |
|
|
|
||
|
Alan N. Marcus member since: 3/4/2006 |
Your guess is as good as mine. Not enough information given. This is the boss meter therefore somewhat complex. Meter working with other flash units? Meter works when flash is manually triggered? Meter works OK when used as light meter for continuous light? My first guess is pilot error (check the manual). Tell us more! Alan Marcus 5/9/2007 8:26:22 PM |
|
|
|
||
|
To participate in the Forum, become a BetterPhoto member or Sign In.
|
||
|
|
Copyright © 1996-2013 BetterPhoto.com, Inc.® All Rights Reserved.